$99.99 $69.99

60" LED Tailgate LED Strip For Trucks and SUVs

  • Brake, Running, Hazard, Reverse and Turn Signal Light Functions
  • Provides Clear And Effective Signaling to Other Drivers
  • 60 Red and 24 White High Intensity LEDs for Maximum Visibility
  • 3M Tape & Screws Provided for Easy Installation
  • Fits Most Full Size Trucks
  • Size: 152CM
  • 60" LED tailgate light bar suitable for most pick-up trucks and SUVs


60” Red and White LED Tailgate Light Bar is a slim yet durable LED light bar designed to bring your truck added safety and visibility with running, brake, reverse, hazard and turn signal light functions to your vehicle’s tailgate. Each water resistant light bar includes 60 red LEDs to provide your truck with the best illumination possible to clearly and efficiently signal other vehicles on the road. Also includes 24 white reverse light LEDs for even further functionality. Plug and play connectivity with the included standard flat 4 pin trailer connection harness to provide highly visible brake, running, hazard and turn signal light functions. Connect the additional white wire to your vehicle’s reverse light power wire for an added reverse light ability. For trucks that do not have a standard flat 4 pin connection, easily splice the wires for a secure hard-wired connection. 3M tape and screws are provided for a fast and trouble-free installation. With its 60” in length, it will easily fit most full size trucks however a precise measurement of your tailgate is recommended before purchasing.


LED Tailgate Light Bar Installation Guide


Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will void all warranties. 

Please read the following instructions thoroughly before installing this kit.

1. First using a tape measure, measure the lip under your trucks tailgate to ensure there is enough clearance to mount your tailgate light bar.

2. Following your trucks owner’s manual, carefully remove the tailgate from your truck.

3. Use the included 3M tape to temporarily mount the LED light bar to your trucks tailgate.

4. Using a 1/8th drill bit, pre drill the four mounting holes into your trucks tailgate, this will make the following step much easier.

5. Securely mount the tailgate light bar to your truck using a drill and the provided screws.

6. Run the power wire with flat 4 pin connector behind your bumper and to your trucks flat 4 pin connection. You may need to secure the slack in the wire so that it does not hang below the bumper.

7. Carefully remove one of your tail light assemblies.

8. Power your truck on and put it into reverse, so that your factory reverse lights are illuminated. It is imperative that you set the parking brake.

9. Return to the rear of your truck and remove the bulb from your reverse light.

10. Using a volt meter, find the positive 12 volt wire that powers your reverse light.

11. Once you have found your factory reverse light wire, use a wire stripper to cut and strip the wire.

12. Run the light bar’s white reverse wire to your factory reverse wire.

13. Use a butt connector to connect the tailgate bar’s white reverse wire to the trucks factory reverse wire. You can also solder or use a 3M™ Scotchlok™ type connector to secure this connection.

14. Now you can re-install your tail light assembly and tailgate, and test your tailgate light bar for full functionality.


  Flat 4 Pin Connector Diagram:

1 - Ground

2 - Running Lamp   (All Red LED 50% lighting up )

3 - Left Turn Signal (Amber LED Scanning   from middle to left) & Brake Light ( All Red LED 100% lighting up )

4 - Right Turn   Signal (Amber LED Scanning from middle to right) & Brake Light ( All Red   LED 100% lighting up )



Customers who bought this product also purchased