[LED Resistor]

It's the nature of LED bulbs to have different current draws than stock halogen bulbs. For some cars this current draw difference could cause "bulb out" warnings, No flashing or fast blinkers. This is normal and not due to a defect. To correct this you would need to install these 50W6oHm load resistors to balance out the current draw. 

Since this load resistor is universal fit, wire splicing might be needed. 4 T-taps are included for easy installation (see pictures)


Brand new and high quality
Can be used with LED turn light of cars
Solution for too fast blinking or no blinking of turn signal
Each LED Turn Signals requires one resistor
Power: 50W
Resistance: 6 Ohm
Voltage: DC 12V
Dimensions: approx. 50 x 22 x 17 mm (1.97 x 0.9 x 0.6 inch)

These load resistors may get really hot. Please mount them on metal surface and not in contact with any plastic parts

Fix turn Signal, hyper flashing, bulb out problems
Work for LED light bulbs such as 1156 1157 3156 3157 7440 7443 etc ...
This 6 Ohm, 50 Watt resistors can be connected across the turn signal bulbs to simulate the load of a regular filament bulb (2 Amp load). This will solve LED related turn signal problems such as hyper flashing, no flashing or burnt out bulb indications. One resistor is required for each turn signal bulb.

Connection Instructions:

Connect one wire to ground and the other wire to the turn/brake wire. You can use the T taps so you do not have to cut your car's wiring. One Load Resistor is required for each turn signal bulb. For more detail, please check Install LED Load Resistors.